Collectors Edition Saber – KR Rey Scavenger

Original price was: $342.00.Current price is: $95.99.

No-Questions-Asked Returns

7 Days of Hassle-Free Returns

7 days return and exchange

Quality at its Finest

Without doubt, one of the most impressive engineering contributions to the saber comunity. KR sabers teamed up with Dennis Lukyanov and Goth 3Designes to produce by far and away, the most accurate Rey inspired hilt from the end of Episode 9 “The rise of Skywalker”. Using over 100 screws, this is truley and engineering masterpiece. Installed by Sabersense and weathered by Multiverse props. This saber comes with a 1″ neopixel blade. Collectors edition magazine included. Not designed for duelling

Hilt: KR Rey Scavenger
Chassis: Goth 3d Eco Chassis
Installed By: Kyber Kustoms
Control Board: Proffieboard v.2.2.
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 15 minutes
LED Wiring Layout: LED Pad 2/3, Data 1 Main Blade

Hilt Length – 31 cm
Default Blade Length – 36″
Other Blade Options – 32″ and 28″
USB-C Charging
Includes charger, screws and hex key