KR Sabers is on of the most the most sought-after and collected saber makers in not only the UK but the whole world. He has teamed up again with One Replicas to produce this incredibly accurate Obi Wan Inspired hilt from Episode 1 “The Phantom Menace” . Made from AL6061 with anodised black pieces giving an authentic feel and beautiful finish. Please note the aluminium parts are polished and not plated. Regular maintainence may be required to sustain the finish. KR recommends Autosol and Mothers Mag metal polish and a clean micro fibre cloth. Installed by Blackstar Sabers with a 3d printed chassis by Goth3Designes. This sabers comes with a 1″ x 36″ blade. This saber is not designed for duelling. Collectors edition magazine included.
Hilt: KR OWK Apprentic 1
Chassis: Goth 3D Eco Chassis
Installed By: Blackstar Sabers
Control Board: Proffieboard v.2.2.
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 15 minutes
LED Wiring Layout: LED Pad 2/3, Data 1 Main Blade
Hilt Length – 28 cm
Default Blade Length – 36″
Other Blade Options – 32″ and 28″
USB-C Charging
Includes charger, screws and hex key









Reviews
There are no reviews yet.