Denis Lukyanov Creepy Uncle
A Luke Skywalker saber inspired by flashback scenes in The Last Jedi,
This hilt has been installed by Ryan at BlackStar Sabers using a Goth-3D chassis.
https://www.instagram.com/blackstarsabers/
Saber comes with Ltd Edition ‘Saberist’ Magazine designed by Chris Carter from Sabersence specifically made for this Saber
https://sabersense.square.site/
Specifications:
- Hilt: Creepy Uncle By Denis Lukyanov
- Chassis: Goth-3D Removable
- Installed By: BlackStar Sabers
- Control Board: Proffieboard v.2.2.
- Operating System: ProffieOS 5.9.
- Switch Programming: SA-22C two-switch setup
- Blade Fitting: 1 Inch Neopixel (Not Included)
- Blade Programming: 132 pixels, Data Pad 1
- Neopixel Connector: Shtok 7 Pin
- Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
- Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
- LED Time Out Delay: 15 minutes
- LED Wiring Layout: LED Pad 2/3, Data 1 – Main Blade, LED Pad 4 – Green Blade, LED Pad5 – Red Blade
Sound Fonts:
- Feautres 27 Sound fonts, including fonts by Kyberphonic & KSith
https://www.kyberphonicfonts.com/
https://www.ksithsaberfonts.com/
All parts and components bought from The Saber Armory
https://thesaberarmory.com/




















Reviews
There are no reviews yet.