Collectors Edition Saber – 89 Sabers MPP Darth Vader

Original price was: $311.00.Current price is: $99.99.

No-Questions-Asked Returns

7 Days of Hassle-Free Returns

7 days return and exchange

Quality at its Finest

89 Sabers MPP

A Darth Vader saber inspired by A New Hope and Empire strikes back, this hilt has been installed by Jimmy from Jimmy’s Saber Junk himself using his crystal reveal chassis, the crystal is wired to mimic blade colour and uses a recharge port and kill key, this saber comes with all the parts to set up in either New Hope or Empire Strikes Back configuration.

https://www.instagram.com/jimmys_saber_junk/

This saber does not come with a blade and is not designed for duelling

Comes with grip guide, grips and blade plug, switches, wire pieces, chassis colour may differ

We can add a Nexus neopixel blade for an extra £50

Specifications:

Hilt: 89 Sabers MPP
Chassis: 3D Printed with crystal chamber
Installed By: Jimmys Saber Junk
Control Board: Proffieboard v.2.2.
Switch Programming: SA-22C two-switch setup
Blade Fitting: 1 Inch Neopixel (Not Included)
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 15 minutes
LED Wiring Layout: LED Pad 2/3, Data 1, Main Blade – LED Pad 5, Data 2, Crystal, sub-blades