89 SABERS OBI WAN KENOBI
A Obi Wan Kenobi inspired saber from Revenge of the Sith, this is a screen accurate prop replica, this hilt has been installed by Ryan at BlackStar Sabers using a Goth-3D chassis – https://www.instagram.com/blackstarsabers/
Saber comes with Ltd Edition ‘Saberist’ Magazine designed by Chris Carter from Sabersence specifically made for this Saber
36″ Neopixel Blade included
https://sabersense.square.site/
Specifications:
Hilt: 89 Sabers Ben Kenobi Episode III
Chassis: Goth-3D
Installed By: BlackStar Sabers
Control Board: Proffieboard v.2.2.
Operating System: ProffieOS 7.13.
Switch Programming: SA-22C two-switch setup
Blade Fitting: 1 Inch Neopixel
Blade Programming: 132 pixels, Data Pad 1
Neopixel Connector: Shtok 7 Pin
Battery: KeepPower 18650 3.7 volts, 15 amp maximum discharge, protected PCB
Speaker: KR Sabers, 28mm, 2 watt, 4 ohm
LED Time Out Delay: 5 minutes
LED Wiring Layout: LED Pad 2/3, Data 1, Main Blade
Hilt Length – 28.5 cm
Blade Diameter – 1″
2.1mm Recharge Point
Includes charger, screws and hex key
Sound Fonts:
Feautres 30 Sound fonts, including fonts by Kyberphonic
https://www.kyberphonicfonts.com/
All parts and components bought from The Saber Armory
https://thesaberarmory.com/



















Reviews
There are no reviews yet.